Santec 2270LM - Manual (Page 2)

INSTALLATION INSTRUCTIONS
FLUSH BOTH SUPPLY LINES BEFORE INSTALLATION
.
AFTER FLUSHING , SHUT OFF BOTH SUPPLY LINES.
MINIMUM HOLE SIZE FOR THE SPOUT AND HANDLE TRIM IS 1 1/4 ” AND MAXIMUM OF 1 1/2 ”
VACUUM BREAKER INSTALLATION
1
- Remove the complete vacuum breaker trim (1) from the cartridge (11).
From the underneath of the sink, insert the vacuum breaker cartridge (11) through the
center hole of the sink with the one of 2 conical black Soft Seating China Seals inserted.
- From the top of the sink, insert the second black Soft Seating China Seal, the White Nylon
Slip Washer, then the black Plastic Inverted Lock Nut onto the Cartridge (11).
Tighten it firmly.
- Screw the Trim Cylinder onto the Cartridge (11). Tighten Firmly.
- Slip the Handle onto the Cartridge stem and secure it with the brass screw.
- Clip the Handle Cap onto the Handle after the installation is complete to check for the
water flow options.
HANDLE TRIM INSTALLATION
1
- For proper handle turning direction, install the handle with the “cold” blue label (7)
at the right side of the sink (looking from the front) and the handle with the “hot”
red label at the left side of the sink.
- Both hot and cold side handle trims are pre-assmbled for faster installation.
- Remove the valve body mounting hardware (10) from the valve body. Slip the
valve body’s flexible hoses from the top of the sink or counter through the
appropriate hole next to the vacuum breaker. Make sure the handle flange washer (3)
is properly placed underneath of the flange and gently pressed against the sink
top. Aim the tee connecting hoses (8) toward the Y- connector (12).
2
- From beneath of the basin or counter, screw the valve body mounting
hardware (10) back to the valve body. First the rubber washer, then the white
nylon washer and lastly the brass lock nut.
- Align the lever handle properly against the sink.
Tighten the lock nut until it secures the valve body firmly.
3
- Loop and connect the flexible hoses (8) to the Y-Connector (12). Tighten to avoid
leakage.
- Connect and tighten the Inlet hoses (9) to the supply lines.
PAGE 02
Black plastic lock nut
2270LM _ _
Trim Cylinder
Handle
Screw
Handle Cap
SANTEC SANTEC
Rubber washer
SANTEC SANTEC
Rubber washer
Metal washer
Brass lock nut
Black Soft Seating China Seals
Black Soft Seating China Seals
White Nylon Slip Washer
INLET HOSE INLET HOSE