Santec 5620MO - Manual (Page 2)

Page 02
mounting
hardware
wing nut
brass lock nut
washer
gasket
INSTALLATION INSTRUCTIONS
S POUT I NSTALLATION
Step 1.
• Remove the mounting hardware from the spout.
Step 3.
• From below, slip notched washer and gasket
over spout shank. Align notched washer and
gasket to allow pop-up rod to pass through.
• Attach wing nut and brass lock nut.
Step 2.
• Apply a ring of silicone caulking around hole
designated for spout.
DO NOT USE PLUMBERS’ PUTTY WHICH CAN
DAMAGE FINISH.
• Insert spout through center hole sink or
countertop.
Step 4.
• Secure spout by tightening the two screws on
wing nut.
• Thread tee connector and washer to spout
shank and tighten to seal.
SSIILLIIC
CO ON NE
COLLECTION
WIDESPREADS