Santec 708460 - Manual (Page 2)

INSTALLATION INSTRUCTIONS
MARKING
1.
-
Mark the vertical distance of 23 and ½ inch on the wall.
- This is the center distance between the two cylindrical holders at the
two ends of the slide bar.
- Draw two circles having their center as two marked points.
- Try to make them exact circles with defined centers, insert screws
through the four small holes in the pedestal.
- Tighten them firmly.
ASSEMBLY
1.
- Cylindrical holder for the slide bars are assembled with the bar.
- Put mounting screw through the hole in the base body.
This will go into the hole at the top of the mounting post sub
assembly.
- Firmly tighten it.
- Now slide bar and holder assembly (both ends) on the earlier
installed pedestal in such a way so that this assemble in the two
blind holes in the post.
- Align them in such a way so that mounting spindle locates
in the middle.
708460_ _
PAGE 02
23 ½”
W
a
ll
W
a
ll
Mounting post
Hole in the post for screws
Slide bar grooved end
f
0.235”
23 ½”