ScanTool 5100 ECUsim - Manual (Page 5)

Programming Manual
ECUSIMPMB www.obdsol.com 5 of 13
DRA ecu_id, fault_set, dtc Add permanent DTC ● ●
DRDA ecu_id, fault_set Delete all permanent DTCs ● ●
DSA ecu_id, fault_set, dtc Add stored DTC ● ●
DSDA ecu_id, fault_set Delete all stored DTCs ● ●
Table 3 – ECU Commands
Command Description S P U
E ecu_id, on|off Set ECU on or off ● ●
EA ecu_id Add new ECU ● ●
EAF ecu_id, functional_addr Set functional address ● ●
EAP ecu_id, physical_addr Set physical address ● ●
EAPA ecu_id, protocol, physical_addr,
functional_addr, [can_id_type]
Add address pair to an ECU (for system
managed ECUs) ● ●
EAUPP ecu_id, on/off Set auto update protocol properties on or off ● ●
EC ecu_id, “calid” Set calibration ID ● ●
ECD ecu_id Delete calibration ID ● ●
ED ecu_id Delete ECU ● ●
EDA Delete all ECUs ● ●
EL Print ECU list ● ● ●
EN ecu_id, “ecuname” Set ECU name ● ●
END ecu_id Delete name ● ●
EP ecu_id, preset Set protocol preset ● ●
EV ecu_id, “vin” Set VIN ● ●
EVD ecu_id Delete VIN ● ●
Table 4 – Freeze Frame Commands
Command Description S P U
FA ecu_id, fault_set, frame_num Add frame ● ●
FD ecu_id, fault_set, frame_num Delete frame ● ●
FPA ecu_id, fault_set, frame_num, pid_num,
pid_data
Add PID to frame ● ●
FPD ecu_id, fault_set, frame_num, pid_num Delete PID from frame ● ●
FPSD ecu_id, fault_set, frame_num,
pid_num, pid_data
Set frame’s PID to new value ● ●
FT ecu_id, fault_set, frame_num, dtc Set frame’s DTC ● ●
FTD ecu_id, fault_set, frame_num Delete DTC from frame ● ●