Ready to watch some tv, Starting up the x32 lcd hdtv, If you have connected antenna or cable to the tv – Sceptre X320BV-FULLHD User Manual
Page 20
- 20 -
www.SCEPTRE.com
SCEPTRE X32 HDTV User Manual
Ready to Watch Some TV?
Starting up the X32 LCD HDTV
1.
Make sure your power cable is connected and the standby red light in the
front of the TV is lit up.
2.
Check all your connection cables off the side or the back of your TV and also
your AV devices. Make sure they are all connected securely.
3.
Turn on your TV and other AV devices if necessary.
4.
Select the correct source according to the Connecting pages.
If You Have Connected Antenna or Cable to the TV…
If an antenna or cable is connected to your TV’s ATSC/NTSC port, you will need to use
the source button on the remote control or the source button on the right side of the TV
to switch to TV (Cable / Air) and auto-scan for channels.
1.
Open up the OSD by pressing the MENU button on the remote control.
2.
Make sure CHANNEL is highlighted; if not please use the ◄ or ► buttons to
select CHANNEL then press the ▼
direction button to switch to ANTENNA.