Sceptre X505BV-FHDU - Manual (Page 21)

- 21 -
www.SCEPTRE.com
SCEPTRE X50 HDTV User Manual
Connecting to a PC with VGA and 3.5 mm minijack …
1. Make sure the power of HDTV and your PC is turned off.
2. Obtain a 15-pin D-Sub VGA cable; connect to the VGA output of your PC and the other
end to the VGA port on the back of your
HDTV .
3. Obtain a 3.5 mm Mini-jack, connect to the audio out of your PC and the other end to the
VGA Stereo Input port.
4. Turn on the power of the HDTV and your PC.
5. Use the remote control’s source button or the source button on the TV to switch to PC.
6. Change your PC resolution to 1920x1080 at 60hz refresh rate.
7. Press MENU to use the OSD’s PICTURE option.
8. Under the PICTURE option select PC Settings.
9. Under PC Settings use AUTO ADJUST to adjust the screen.
Please Note :

For the best results, please set your PC resolution to 1920x1080 at 60 Hz.
Please refer to the PC or graphic card’s manual for further instructions on how
to set your resolution and refresh rate.

Please refer to your PC manual for video output requirements of the video card.

The VGA port of the TV features a power saving mode which will automatically
turn off the TV, if there’s no signal provided for more than 5 minutes.