Sceptre SP05032 - Manual (Page 6)


Safety Information
See product enclosure for safety-related markings.
Use proper power sources – Plug the product into a
proper power source, as described in the operating
instructions or as marked on the product.
Information about products that
generate electrical noise
The SoundPal™ Wireless Mobile speaker complies with
FCC and Industry Canada RF radiation exposure limits set
forth for general population. The system must not be co-
located or operating in conjunction with any other antennas
or transmitters.
This device complies with Part  of the FCC Rules.
Operation is subject to the following two conditions:
() This device may not cause harmful interference.
() This device must accept any interference received,
including interference that may cause undesired operation.
USA
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 
of the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
.
6. and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However
this is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, you are
encouraged to try to correct the interference by one or more
of the following measures:
Re-orient or relocate receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment to an outlet on a different circuit
than the one to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.
Any changes to this device not expressly approved by Scep-
tre Inc may void the user’s authority to operate this device.
Canada
This digital apparatus complies with the Canaidan ICES-
003 Class B specification
The radio communication device incorporated into this
apparatus meets all requirements of the Industry Canada
standard RSS-0.