Shellab SMI1EM-2 - Manual (Page 7)

CONTROL PANEL OVERVIEW
4.1 Power Switch: The main power I/O (on/off) switch controls all power to
the unit and must be in the I or ON position before any systems are
operational.
4.2 Temperature Controller: This control is marked SET TEMPERATURE
and consists of the digital display and Up/Down arrow pads for inputting
set point temperature and calibration.
4.3 Circuit Breaker / Fuse: This control is adjacent to the power cord and
provides protection for the unit
’s electrical circuitry against power
fluctuations. The circuit breaker, when tripped, must be reset by pushing
in the extended button for the unit to continue operation. The fuse, when
blown (on CE units in place of the circuit breaker) must be replaced before
the unit can continue operation.
Section
4