Curtis SRCD-719 - Manual (Page 8)

7
Radio
Operation
At the front of the CD micro system, or using
the remote control, press POWER, to switch
the CD micro system on. The LCD display
will light up.
Press either TUNER/BAND button on the
remote control or the TUNER on the unit to
select the radio tuner.
Tuning
Press either TUNER/BAND on the remote
control or TUNER/BAND on the unit to select
between FM and
AM bands.
Use the tuning UP/DOWN button on the
remote control or on the unit to select the
desired station. The frequency will display on
the LCD display.
Pressing any of the tuning buttons briefly will
change the frequency by one increment.
Pressing and holding the button for a couple of
seconds will cause the tuner to search for
the next radio station.
Pressing any of the tuning buttons during a
search will stop the search.
FM
FM Antenna
Fully extend the FM antenna wire and
position it to obtain the best FM reception.
FM Stereo
The CD micro system is capable of receiving
stereo FM broadcasts. When you tuned to a
stereo broadcast, ‘STEREO’ will be
displayed.
AM
AM Loop Antenna
For AM reception broadcasts are picked up
through a loop antenna that plugs into the
back of the unit.
The antenna assembly has a fixing system
attached that can be folded to form either a
stand or wall mounting as shown in the
figures opposite. The wall mounting has two
holes for round head screws. These are not
supplied.
Note: It is normal for the position of the
antenna to be adjusted to achieve the best
reception. If selecting the wall mounted option
ensure that you can receive the radio stations
you listen to before fixing.
Folded for
wall
mounting
As supplied
Folded to
form a
stand