Sigtronics SEP-40 - Manual

igtronics
®
S igtronics
®
S
…when it counts!
Model SEP-40
Hearing Protector Instructions
The SEP-40 series of hearing protectors are adjusted at the factory
for immediate use.
The headband is adjustable through a full range of motion, and
the locking nuts may be tightened to allow you to custom fit the
hearing protector. Place the hearing protector over your head and
adjust the slides up until minimum pressure is felt on the top of
your head. For maximum noise attenuation, the clamping pressure
of the headband has been set at the factory. Releasing the clamp-
ing pressure by bending the headband is not advised, because loss
of attenuation will result.
The hearing protector parts may be cleaned with mild soap and
water using a soft cloth. Then dry immediately.
Cleaning will help the hearing protector maintain its “like new” con-
dition for many years.
continued on back…
WARRANTY
Your hearing protector is covered by a limited one-year parts and
labor warranty. Please see the enclosed warranty card for details.
You may refer to the parts list on the reverse side, if you choose to
replace parts yourself. The parts list describes parts for this particu-
lar hearing protector only. Parts lists for other models are available
on our Web Site or can be obtained by contacting Sigtronics Corpo-
ration.
Sigtronics Corporation
178 East Arrow Highway
San Dimas, CA 91773
Phone: 909 305-9399
E-mail: [email protected]
Web Site: www.sigtronics.com