Cobra Electronics MicroTalk 2-Way Radio - Manual (Page 2)

ᕡ Pull lock tab down
to remove battery
cover.
ᕢ Insert four “AAA”
batteries. Position
batteries according
to po l a ri ty marki n g s.
Operation
2
Note
Batteries not included with
microTALK 2-way radio. Always
use high quality alkaline or
NiMH batteries.
Only the Cobra NiMH bat-
tery pack (Part #FA-BP) can
be recharged.
Incorrect positioning can
damage both the batteries
and the unit.
Note
When batteries are low
the i n d i ca tor
w i l lb l i n k .
Install Batteries Battery
Installation
Operation
3
Note
You will be able to receive com-
munications only when the
unit is in the FRS,AM/FRS and
FM/FRS modes.
Turning On Your microTALK Turning
On Your
microTALK
ᕡ Push and hold the POWER button for
3 seconds. An audible tone will indicate the
unit is on. (The unit will return to the mode
last selected before it was shut off).
Illuminating the Display Illuminating
the Display
ᕡ Push and release LIGHT/MAX RANGE
button to illuminate display for ten seconds.
PUSH &
HOLD
PUSH &
RELEASE
FRS_115(3979).v2NEW 12/5/00 1:50 PM Page 2