Solvline CS-CAN User Manual - Manual (Page 29)

4.
Appendix
- Appendix: CS-CAN v1.0 commands
This page describes about commands in CS-CAN v1.0 converter.
Please refer to Command
manual for more information.
C : Configuration Mode A : Active Mode
Command Description C A
VA
Display current firmware version ● ●
MO
Return current CS-CAN mode ● ●
RS
Retrieve configuration for serial communication in CS-CAN ● ●
RC
Read CAN Baud rate and Spec. from CS-CAN ● ●
+++
Enter Configuration mode ●
tlllLDD..
Transmit standard CAN Data Frame ●
TlllL
Transmit standard CAN Remote Frame ●
ellllllllLDD..
Transmit extended CAN Data Frame ●
EllllllllL
Transmit extended CAN Remote Frame ●
--
Exit Configuration mode ●
&F
Reset all settings to factory default in CS-CAN ●
WCBS
Set CAN Baud rate and Spec. in CS-CAN ●
WSBDSP
Configure settings for serial communication in CS-CAN ●
CStT
Change transmit command of Standard CAN Frame ●
CEeE
Change transmit command of Extended CAN Frame ●
HRE
When transmission of CAN Frame is complete, return
OK<CR> ●
SV
Save internal configuration value of CS-CAN ●
SR
Reboot CS-CAN ●
FW++
Upgrade firmware ●
※ To apply with modified configuration, you must save (SV command) and reset (SR
command).