Solvline Eddy DK Ver 2.20 - Manual (Page 70)

Chapter 9. Appendix
9-4
Once the IP information is confirmed start recovery.
install bootloader <name of bootloader firmware> ; When recovering bootloader area
install os <name of OS firmware> ; When recovering OS area
install fs <name of File System firmware> ; When recovering File System area
install config <name of Congif firmware> ; When recovering Config area
When recovering Config area, MAC address assigned to Eddy is lost. Therefore you must connect via telnet and use
def command to change MAC address to one assigned to Eddy(See the label attached to the product) after
recovering config area.
Proceed as follows and it will recover by downloading image file from TFTP server configured.
The next shows OS recovery procedure.
U-Boot> setenv serverip <TFTP server IP address>
U-Boot> setenv ipaddr <Eddy IP address>
U-Boot>
U-Boot> install os eddy-os-20a.bin
TFTP from server 192.168.0.220; our IP address is 192.168.0.223
Filename 'eddy-os-20a.bin'.
Load address: 0x20000000
Loading:#######################################################################
###########################################################
done
Bytes transferred = 1112284 (10f8dc hex)
Erasing
sector ...........................................................................................................................................................
.......done
Erased 272 sectors
Copy to Flash... .done
Un-Protected 1 sectors
Erasing Flash...Erasing sector .done
Erased 1 sectors
Writing to Flash... .done
Protected 1 sectors