Sonics VCX134PB - Manual (Page 12)

AMPLITUDE:
Desired amplitude must be set in order for the Ultrasonic
Processor to be operational. AMPL. displays the amplitude selected e.g. 40%. To
set the amplitude at 40% when the ultrasonics is off, press the
AMPL key and the
▲ or ▼ key for a 40% reading on the screen, and then press the
ENTER/REVIEW key.
The screen will display:
Ampl 40 %
The Ultrasonic Processor is now ready for continuous operation. To energize the
ultrasonics, press the
START key or the footswitch. To de-energize the ultrasonics, press
the STOP key or release the footswitch.
To increase or decrease the amplitude in small increments when the ultrasonics is on,
depress the
AMPL key to display Amplitude Setting on the screen, then depress the ▲ or
▼ key, as required.
NOTE
To clear an erroneous entry press the CLEAR key.
NOTE
The START key and footswitch are mutually exclusive. If the process is initiated
by the START key, the footswitch becomes inoperative. If the process is initiated
by the footswitch, the STOP key becomes inoperative.
12
Table of Contents
Table of Contents