Sonics VCX134AT - Manual (Page 6)

6
INSTALLING THE ULTRASONIC PROCESSOR
The Ultrasonic Processor should be installed in an area that is free from excessive dust,
dirt, explosive and corrosive fumes, and extremes of temperature and humidity.
SECTION II – OPERATION
FUNCTIONS OF KEYS, CONTROLS, INDICATORS, AND CONNECTORS
FRONT PANEL
LCD screen
Displays prompts and the following control parameters:
Amplitude selected
Amount of output power delivered to the probe in watts, and as a
percentage of either 100 watts or 130 watts.
Accumulated amount of energy in Joules delivered to the probe.
CLEAR
Key
Clears preceding entry.
ENTER
REVIEW
Key
Used to enter the amplitude selected, and view amplitude, power, and
energy
START/STOP
Key
Starts or stops the ultrasonics. In the STOP mode the red indicator goes
off.
Key
Switches the main power on.
Key
Switches the main power off.
AMPL
Controls the amplitude of vibration at the probe tip.
▲ ▼
Key
Used with the AMPL key when the unit is on stand-by to set the amplitude
of vibration at the probe tip. Also used to increase or decrease the
amplitude in small increments while the unit is running. To accomplish
this task, depress the
ENTER/REVIEW key twice to display
AMPLITUDE CONTROL, then depress the ▲ or ▼ key as required.
CAUTION
Operating the equipment with voltages different from those specified, or with
voltages with high power transients, will cause components within the power
supply to fail.
|
O