Sonics 1098 Press - Manual (Page 20)

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
I N S T R U C T I O N M A N U A L • M O D E L 1 0 9 8
19
STROKE SPEED ADJUSTMENT
The velocity at which the horn descends and returns can be adjusted via the
speed controls. These controls are factory adjusted for average operating
conditions and should not require further adjustment. However, if a minor
adjustment is necessary, adjust in small degrees. Turn clockwise to slow the
extend speed, and counterclockwise to increase the return speed.
The speed controls are 2 small threaded screws located in the top of the
press as shown below.
Turn the Extend Speed Control screw clockwise to slow the extend speed,
counterclockwise to increase the speed. Turn the Return Speed Control screw
clockwise to slow the return speed, counterclockwise to increase speed.
Excessive velocity may be
unnecessary and harmful
to the system.
EXTEND
SPEED
CONTROL
RETURN SPEED
CONTROL
Go To Top Of Document