Sonics E-Press - Manual (Page 12)

Sonics E-Press Manual Page 12
Cable Connections for Stepper Controller and Ultrasonic Power Supply
The drawings below and on the next page show the back connections of the Stepper and Ultrasonic controls.
Match the cables from the press to the appropriate connections noted below. (The interconnecting cables will
be supplied with your system.)
Stepper Controller
1. J1 - Control cable from press to Stepper Control
2. J2 – 9 Pin base cable from base to stepper control
3. J3 - RS232 Communication to PC***
4. J4 - Power outlet to the press head for motor drive
5. Power line cord that plugs into the appropriate electrical outlet
6. Line fuse
7. Additional fuse for 220v configuration
***NOTE: The RS-232 cable connected between the PC and Controller must be a straight one-to-one cable
(Do not use a null modem cable.)