Sound Oasis S-100 - Manual (Page 5)

Off –Resume
1. Press the Off-Resume Button to temporarily silence sound output.
2. Press the Off-Resume Button again to restore the same sound at the
same volume and same timer setting.
For example: If you are listening to the 10th
selection of white noise at half volume on the
60-minute auto shut off timer position, pressing
the Off-Resume Button once will silence the
unit. Pressing the Off-Resume Button again will
resume playback of the 10th white noise sound at half volume for another
full 60-minute period.
Headphone Jack
The headphone jack accepts a 1/8" (3.5 mm)
monaural or stereo type plug. Sound from the
speaker will turn off when this jack is in use.
Using Your Unit as a Speaker
You can play music from an iPhone*, iPod*,
MP3 player or CD player through your unit’s
speaker system. To use it this way, connect your
iPhone*, iPod*, MP3 player or CD player to the
Input Jack with a separately purchased cable
with 1/8" (3.5 mm) jacks.
Note: The Input Jack is intended for use with non-amplified inputs only
(Maximum of .05 W).
Reset
Should you experience problems with the proper function of your
unit, you may need to reset the unit’s computer-controlled electronics.
To do so, unplug the unit, wait a few minutes and plug it in again.
*Registered marks of Apple ®
7
To Operate
White Noise Sounds
Your Sound Oasis® White Noise™ unit incorporates 10 different white
noise sounds each with different tone characteristics to suit your personal
preference. Generated from an internal, patent pending white noise
generator, each white noise sound is continuous and nonending with no
annoying loops.
Playing Sounds
Press the Off-Resume button once to start
playing white noise. Press the Sound Selector
button (labeled SOUNDS) to skip to the next white
noise sound. After you skip through all 10 white
noise sounds, your unit will start over again at
the beginning.
Adjusting Volume
Rotate Volume Dial to adjust sound volume.
Sleep Timer
Your unit incorporates an auto off timer with
four positions — CONT for continuous playback;
“30” for auto shut off in 30 minutes;
“60” for auto shut off in 60 minutes;
and “90” for auto shut off in 90 minutes.
Slide the Timer Switch located on the bottom of the unit to your preferred
timer position.
6
Note: You can change the tone of each sound by
pressing and holding down the Sound Selector
button until the tone reaches your desired level.