Source Audio Hot Hand 3 Universal Wireless Adapter - Manual (Page 14)

14 | Status LEDs and troubleshooting
LED State Description
Ring LED — fast blink Ring is being charged.
Ring LED — slow blink Ring is trying to find a receiver to link up with. Make
sure that the receiver is plugged into the correct port
and is powered up properly. If it still doesn’t work,
cycle the power.
Ring LED — off Ring is off or the battery charge is complete. Press
the ring ON/OFF switch to turn the ring on. If the ring
does not turn on, check the directions for charging
the battery above.
Ring LED — solid [no blink] Ring is on and is communicating with the receiver.
Receiver [status] LED — Receiver is looking for a ring. Turn on the ring to
slow blink complete the link.
Receiver [status] LED — Temporary loss of signal from ring. Once the ring and
intermittent blink receiver are properly linked, the STATUS LED will
indicate that the signal from the ring is being properly
received. If the ring signal goes out of range, is
blocked, or if there is interference on the channel, the
STATUS LED will turn off temporarily to indicate that
the ring signal has been lost. Bring the ring back in
range or cycle the power to find a new channel.
Receiver [status] LED — off If the STATUS LED is off, the receiver is not being
powered. Make sure that the DC adaptor is plugged
into the receiver unit or that the sensor cable is con-
nected to a Soundblox pedal.