Source Audio Hot Hand Wah - Manual (Page 8)

SAVE
PRESET
03
PRESET
04
EFFECT MOTION
PRESET
02
PRESET
01
ON/OFF
VOLUME SWELL
STRUM
FLAIL PICK
BAND PASS
LOW PASS
AUTO WAH
01
02
03
04
LO
HI
LO
HI
CALIBRATE INVERT SENSOR
FREQUENCY
CLASSIC WAH
MULTI PEAK
MOTION CONTROLLED WAH FILTERS
ON/OFF SELECT
GUITAR OUT
This ¼-inch output is where you connect your amp or the next pedal in
your chain.
EXPRESSION OUT
This jack allows you to send the Hot Hand control signals to other effects
devices that accept an expression input. This output signal defaults to an
analog voltage ranging from zero to
3.3VDC . This signal is “tip hot”. The maxi-
mum voltage can be adjusted up to 4.5VDC to accommodate other devices
that require higher voltages. For details on adjusting the voltage range see
the Hidden Features and Controls section on page
20 . Note that this output
is active at all times when the Control Unit power is On. BE SURE TO READ
THE DOCUMENTATION ON ANY DEVICE YOU USE WITH THE HOT HAND IN THIS
CONFIGURATION.
9V DC
Connect a 9V DC power supply here if you do not wish to use batteries. Batter-
ies will not be used while the power supply is connected. Power supply must
be
REGULATED , minimum 200mA, and use a NEGATIVE tip plug. Use of a non-
Source Audio approved supply may cause damage and void the warranty. See
our website for a list of approved supplies, www.sourceaudio.net.
Pedals
ON/OFF (left) Pedal
Pressing this pedal once engages the effect that is selected. Touch the pedal
again, the effect is turned off and bypass is on. There is an
ON/OFF LED right
above the pedal that notifies you when the effect is turned on.
SELECT (right) Pedal
The SELECT pedal cycles through 4 PRESETS in a repeating pattern. The 4 LED s
above this pedal indicate which preset has been selected.
ON/OFF pedal Select pedal
Guitar Out
Jack
Expression Out
Jack
9V DC
Power Supply
Jack
Pedals | 15 14 | Connections