Source Audio Soundblox Pro Multiwave Bass Distortion Pro - Manual (Page 3)

Quick Start | 5 4 | Quick Start
3. BRIEF KNOB, FOOTSWITCH, AND BUTTON DESCRIPTIONS
See Controls section for more details.
A EQ AMOUNT: adjusts how much equalizer is applied to the signal.
B DRIVE: the amount of distortion gain applied to the signal.
C PRESET BANK BUTTON: select preset bank A (presets 1 , 2 , and 3 ) or
B (presets 4 , 5 , and 6 ).
D EFFECT KNOB: selects the type of distortion.
E CLEAN MIX: adjusts the amount of clean signal in the final output.
F DISTORTION MIX: adjusts the amount of distorted signal in the final
output.
G HH ENABLE and CALIBRATE: for Hot Hand use only.
H EQ SECTION: the two buttons select the frequency band to edit and
the knob adjusts the value of the selected band.
I FOOTSWITCHES: Enables/Disables a selected preset depending
on the currently selected preset bank. Press and hold to save an
edited preset.
QUICK START
1. POWER
To power the unit, connect the included
DC adapter power supply to
the 9V DC jack (A) on the back panel. Note: Using a different supply
could damage the unit and void the warranty.
2. GUITAR/AUDIO CONNECTIONS
Next, plug your bass guitar (or other instrument) into the jack labeled
GUITAR IN (B) via a standard ¼" cable. Connect your amp (or other audio
device) to the GUITAR OUT jack (C) , again with a standard ¼" cable.
Both input and output are mono signals.
SENSOR
IN
SENSOR
OUT
GUITAR IN GUITAR OUT
9V DC
EXP IN
MIDI IN
SENSOR
IN
SENSOR
OUT
GUITAR IN GUITAR OUT
9V DC
EXP IN
MIDI IN
A
C B
EQ AMOUNT CLEAN MIX 17
MULTI BAND
SINGLE BAND
02
03
04
05
06
07
08
09 10 11 12 13
14
15
16
18
19
21
22
FULL 0
00
20
01
OCTAVE
NORMAL
FOLDBACK
OCTAVE
NORMAL
FOLDBACK
DRIVE DISTORTION MIX
HH ENABLE
CALIBRATE PRESET BANK
4-6
62 125 250 500 1K 2K 4K
+12
-12
0
1-3
< >
+12
-12
0
1 4
2 5
3 6
0
0
(NG) (HG) (HS) (HA) (HR)
MULTIWAVE BASS DISTORTION
CLEAN BOOST / EQ
BACKPAGE
MODE
A E
D
B
C
F
G
H
I