StarTech.com ST121UTPHD2 - Manual (Page 7)

Instruction Manual
4
Preparing Your Site
1. Determine where the local video source (i.e. computer, Blu-ray Player) will be
located and set up the device.
2. Determine where the remote display will be located and place/ mount the
display appropriately.
Notes: Ensure the Extender Unit and the Receiver Unit are situated near an available
AC electrical outlet. Make sure all devices are turned off before beginning installation.
Hardware Installation
1. Install Transmitter Unit
a) Position the Transmitter Unit near the video source (i.e. Computer, Blu-ray Player).
b) Connect the provided HDMI® cable from the video source device (i.e. computer,
Blu-ray Player) to the “HDMI® IN” on the Transmitter Unit.
c) Connect the provided Transmitter Unit power supply.
d) (Optional) If using the ST121UTPHD2 to extend an infrared (IR) device signal.
Connect the IR Transmitter Cable to the IR OUT on the Transmitter Unit, and
Position the extended IR sensor directly in front of the video source’s IR sensor.
Check the manual of your video source device for the IR sensor location.
e) (Optional) If you would like to use a local display, connect an HDMI® cable (Not
provided) from the display to HDMI® bypass.
Note: Only the local or remote display can work at one time. Connecting a display to
the HDMI® bypass will result in the remote display losing signal.
f) (Optional) If also transmitting RS232 signals over Cat5, connect the transmitting
RS232 device to the “RS232” connector on the Transmitter Unit using a DB9 cable
(Not included).