StarTech.com ST12MHDDCRP User Manual
Page 9
Instruction Manual
6
NOTE: These steps can be repeated at each level when adding additional Repeaters up
to 30 levels. Each Repeater has two HDMI® out Links (RJ-45 Connectors) allowing for
the same signal to go in 2 different directions at each level.
3. Install Receiver Unit
d) Position the Receiver Unit near the video display (i.e. television, projector) within
330 ft. (100 meters) from the level up device be it the initial transmitter or
another repeater.
e) Connect the video source to the HDMI® out on the Receiver Unit using an
HDMI® cable.
f) Connect the provided Receiver Unit power supply. The Power LED will light,
and Link LED will turn on after a successful connection between both units is
established. This may take several seconds.
NOTE: The ST12MHDDC receiver (sold separately) should only be used as the last
device in the chain as it does not have an HDMI® out port (RJ-45 Connector).
4. Your source video image will now appear on the Repeater unit(s) attached
video display.