StarTech.com STUTPEA4X - Manual (Page 8)

Instruction Manual
5
1. Turn off the VGA signal source device (computer).
2. Connect the local unit (ST124UTPEA/ST128UTPEA) HD-15 female INPUT connector
to the signal source (computer) using an HD-15 male to male cable.
3. Connect the AUDIO IN connector of the local unit (ST124UTPEA/ST128UTPEA) to the
Audio Out port of the audio source (computer sound card), using a 3.5mm audio cable.
4. Optional: Connect a compatible microphone cable to the MIC IN connector on the
local unit (ST124UTPEA/ST128UTPEA).
5. Connect a VGA monitor to the local unit (ST124UTPEA/ST128UTPEA) 5. HD-15
female OUTPUT using an HD-15 male to male cable.
6. Connect the Local Unit (ST124UTPEA/ST128UTPEA) 6. CAT5 OUT port to the Remote
Unit (STUTPEALR(GB)) using CAT5 cable.
Optional: If you will be using the STUTPEA4X Line Splitter, connect the Local Unit
(ST124UTPEA/ST128UTPEA) CAT5 OUT port to the Line Splitter using CAT5 cable. Once
the Line Splitter has been connected, you have the option of connecting to up to four
remote units (STUTPEALR(GB)) using CAT5 cable.
7. Once each of the Remote Units have been connected to either a Local 7. Unit
(ST124UTPEA/ST128UTPEA) or Line Splitter (STUTPEA4X), connect a VGA monitor to
the HD-15 OUTPUT connector provided by the remote units as necessary.
8. Connect the Remote Unit 8. AUDIO OUT port to the device you will be using to
distribute audio (i.e. stereo receiver, amplifier etc.)
9. Connect the power cord on all units (Local, Line Splitter, Remote).9.
10. Turn on the monitor and PC and audio amplifier.
When situating the Local and Remote Units, please review the maximum distance
capability offered by each component (found in the Specifications section