StarTech.com ST1212T - Manual (Page 8)

Instruction Manual 5
5. Connect the remote display(s) to the “Monitor Out” ports located on the Receiver
Unit using a VGA male/male cable. Each Receiver Unit supports two mirrored
(identical) VGA outputs.
6. Connect the Transmitter Unit to each Receiver Unit, using standard RJ45 terminated
Cat5 cable (see “Preparing Your Site”).
OPTIONAL: If using the ST121EXT Extender Unit(s), the distance between the
Transmitter and Receiver units can be extended by up to an additional 150m / 492ft.
The ST121EXT also supports 2 VGA outputs and requires an AC electrical outlet.
7. Connect the power adapters (provided) to both Transmitter and Receiver Units.
8. Turn on the display device first, followed by the video source.
Driver Installation
No driver or software installation is required on the video source device.
Operation
The ST1212T provides LED indicators, allowing simple operating status monitoring.
Once the power adapter has been connected, the Power LED will become illuminated;
similarly, when the unit is in use (i.e. transmitting a video signal), the Active LED will
become illuminated.