StarTech.com STUTPWALLA - Manual (Page 7)

4
The default setting of H-INV is “OFF”. If H-INV is set to “ON”, the •
horizontal signal output is adjusted. H-INV on the transmitter
must also be set to “ON”.
The default setting of V-INV is “OFF”. If V-INV is set to “ON”, the
•
vertical signal output is adjusted. V-INV on the transmitter must
also be set to “ON”.
Use this setting when noise or sync issues are detected in the
•
signal transfer.
Rear View
* picture may vary from actual product
Power Terminal Block Connector •
RJ-45 Female Connector •
Hardware Installation
Turn off the PC and remote monitor. 1.
Connect STUTPTXWLA Transmitter unit DE-15 VGA female 2.
connector with a DE-15 VGA male to male cable to PC video card.
Connect STUTPTXWLA Transmitter and STUTPRXWLA Receiver
3.
units together with CAT5 UTP cable.
Connect STUTPRXWLA Receiver unit DE-15 VGA female connector
4.
with a DE-15 VGA male to male cable to the monitor/display.
Connect the power adapter on each unit.
5.
Turn on the monitor and PC. 6.