StarTech.com VID2VGATV2 - Manual (Page 7)

Instruction Manual 4
Installation
Hardware Installation
1. Make sure all devices and components are powered off.
2. Connect the video source to the input side of the video converter using either an
S-Video or composite RCA cable (both sold separately).
3. Plug the power adapter into the video converter. The Input indicator LED will light
up steady.
4. If not already set to the correct input, press the Input selector button to change the
input source. The LED will light up green for composite and red for S-Video.
5. Connect the display to the converter using either the VGA to component RCA
breakout cable (included), or a male/male VGA cable (sold separately).
6. Set the Output Signal Mode selector switch along the side of the video converter to
the type of display you are using: “HD” for component and “PC” for VGA.
7. Select the output resolution using the slide switch next to the VGA output
connector. Make sure to select an output resolution that is supported by the display
device.
8. Power on the display device.
9. Power on the video source.
Driver Installation
The video converter is an external pure hardware converter, so no driver or software
installation is required.