StarTech.com DVI2VGA - Manual (Page 6)

Instruction Manual 3
Using the Video Scaler
Once you have connected the desired input and output devices to the video scaler, you can
proceed to test the connection to the television or other display. Turn on the display, and select
the input to which you connected the video switch. Consult the documentation for your display
if you are unsure on how to select A/V inputs. Usually, there will be a button on the display’s
remote or front panel labeled INPUT or A/V. If the display has multiple inputs, you will need to
ensure the input you have selected corresponds to the connectors on the television you used for
the scaler. Power on the devices you connected to the video scaler. Pressing the MENU button
will bring up the on-screen display controls on the screen as follows:
Using the + or - buttons, move the cursor to your desired selection, then press Menu to confirm
your selection and enter the corresponding sub-menu.
Input set up
When selected, a sub-menu for choosing either YPbPr or RGB as your input signal will appear.
Using the + or - buttons on the front of the scaler, select the signal format that matches the
format of your input. Pressing Menu will save your selection and exit this sub-menu.
Output set up
When selected, a sub-menu will appear giving you options as to the desired refresh rate and
resolution. Use the + or - buttons to choose the correct resolution/refresh rate. Pressing Menu
will save your selection and return you to the main menu.
Picture Adjust
This sub-menu allows you to adjust the contrast, brightness and color of the displayed image.
Using the + and - buttons, select the attribute you wish to change, and use the Menu button to
confirm your selection. Use the + or - buttons to increase or decrease the amount of the element
you are modifying, followed by the Menu button to save. Repeat this procedure for each element
as desired. Once you have made the necessary adjustments, use the + or - button to navigate to
the Exit, which will take you back to the main menu. NOTE: using the Reset feature will return all
adjustments back to the factory reset values.
HV Adjust
When chosen, a sub-menu will appear, allowing you to adjust the best horizontal and
vertical position of the picture, using the + or - buttons.
OSD Adjust
Allows you to adjust the horizontal and vertical position of the on-screen menu.