StarTech.com HDMIPATRN2EU - Manual (Page 6)

Instruction Manual
3
Installation
1. The video generator can be powered either by external power adapter or a 9V
battery. To access the battery compartment, flip the unit over and on the bottom
side, will be the battery door. Push in the small tab that secures the door and lift the
door away from the unit.
2. Set the Video Resolution Switch to the desired output resolution for the display
device (i.e. monitor, HDTV, etc) you wish to calibrate/test
Swtich Setting Description
1080p/12 1080p @ 60Hz (12-bit)
1080p/10 1080p @ 60Hz (10-bit)
1080p/8 1080p @ 60Hz (8-bit)
1080i/8 1080i @ 60Hz (8-bit)
720p/10 720p @ 60Hz (10-bit)
720p/8 720p @ 60Hz (8-bit)
480p/8 480p @ 60Hz (8-bit)
3. Connect the video generator to the display device using an HDMI cable or HDMI-to-
DVI adapter/cable.
4. Set the Power Switch to the ON position, and the Power LED should light up solid. If
using battery power, then the battery becomes low, the LED will start to flash.
5. If the display device is HDCP compliant, than the HDCP Error LED should NOT light
up. If the LED lights up, then there is a problem with HDCP verification.
6. The current test pattern should be display on the display device. Pressing the Test
Pattern Selection Switch will toggle through each of the available test patterns.
Test Patterns