StarTech.com VS424HDPIP Manual - Manual (Page 16)

Instruction Manual
13
IP Operation Using Web Browser
Before you begin:
• Power Status must be set to on, and source status must be unlocked
• Ensure step 5. of hardware Setup has been completed.
• Obtain the IP address of the VS424HDPIP using the OSD menu. Access the following
sub menu:
ETHERNET
-> IP
Your IP address will be displayed next to IP.
Note: The switch supports DHCP and it is activated by default. As a result if you
connect it to a piece of network equipment that supports DHCP your IP address will
automatically change. If your network equipment does not support DHCP your
default IP address will be 192.168.5.155
Access IP Operation Web GUI
1. Open your web browser.
2. In the address bar type the IP address obtained from your OSD menu, and press
enter.
3. The VS424HDPIP web GUI is now displayed.
Operate your VS424HDPIP using the Web GUI
The web GUI enables you to remotely operate your VS424HDPIP with basic and
advanced functionality. The below sections outline the features and navigation of the
Web GUI.
Operation Pane
The operation pane gives you a high level overview as well as access to basic switch
operation. The Operation pane is always visible at the top of every page in the Web
GUI.
The Information-in and information-out sections gives you an overview of the
current connected video source and display devices.
The Status section enables you to power off the device.
The Source section enables you to select your desired mode as well as define which
video source devices will be shown on each display.
The Save/Factory section enables you to save and action the customized input and
output corresponding settings.