Basic operations, Setting monitor routes – StarTech.com VS420RDVIA User Manual
Page 7
Advertising
Instruction Manual
4
Basic Operations
Front Panel Operation
Once the unit has been powered on, all 4 red LEDs should be illuminated. Due to the
factory default settings, if all 4 red LEDs are blinking, source 1 is empty. When all 4 LEDs
are always ON then a video signal has been detected at source 1.
Setting Monitor Routes
Route Source 1 or 2 to Monitors 1 through 4 Respectively
Step 1
Press the desired port, for example “4”.
Step 2
LEDs 1 and 2 should now be blinking.
• 1 represents Source 1.
• 2 represents Source 2.
• Green means the video signal has been detected.
• Red means no video signal has been detected.
Advertising