StarTech.com RACKCONSxxxx - Manual (Page 22)

Instruction Manual
19
Hot-key commands - cont’d
COMMAND
HOTKEY
SEQUENCE
DESCRIPTION
Select computer
Left Ctrl + Left
Ctrl + x
Selects the computer connected to
console port “x”.
For a computer connected directly to
the console, “x” would be 1~8 or A~H.
(Ex. Left Ctrl + Left Ctrl + B would select
the computer connected to the “PC B”
port on the console.)
For cascaded computers, you must first
enter the port number of a slave KVM
connected to the console, then enter
the port number on the slave KVM
where the PC is connected.
(Ex. Left Ctrl + Left Ctrl + 3 + 1 would
select the computer connected to port
1 of the slave KVM that is connected to
port 3 on the console.)
Start
Auto-scan
Left Ctrl + Left Ctrl
+ F1
Automatically scans through powered-
on computers.
When keyboard or mouse activity is
sensed, auto-scan pauses until activity
stops.
End Auto-scan Left Ctrl + Left Ctrl Exits auto-scan mode.
Adjust Auto-
scan rate
Left Ctrl + Left Ctrl
+ F3
Scrolls between the different auto-scan
intervals. The console will generate one
to four beeps corresponding to 3, 8, 15,
and 30 seconds respectively to signify
the selected auto-scan interval.