StarTech.com RACKCONV1901 - Manual (Page 7)

Instruction Manual
4
How to Use
Connecting the Console
To connect the LCD console to a computer, perform the following steps:
1. Turn off your computer.
2. Connect the VGA video cable from the VGA output on the computer system to the
VGA port on the rear of the rack console.
3. Identify and connect the USB connector on the rear of the rack console to a USB
port on the computer system.
4. Connect the AC power cord to the power inlet on the console. Connect the
remaining end of the AC power cord to an available power outlet.
Turning on the Console
Make sure all cables and the power adapter are connected properly. Be sure to tighten
all connector screws. Grab the front handle and pull the console all the way out then
lift the panel up. The power LED underneath the LCD monitor will be green light.
Configuring Display Settings
After connecting the rack console and turning on your computer, you may need to
configure one or more of the following display settings to allow the computer to
display at the console’s native resolution. See Specifications for the correct resolution
mode for your model.
• Display mode (also called desktop area or video resolution)
• Refresh rate (also called vertical scan rate or vertical sync)
• Color depth (also called color palette or number of colors)
VGA input
USB output
Power Connector