StarTech.com PCM815SHNA - Manual (Page 11)

The General Tab
Select Com Port: This option changes the serial port that the host
computer will use to connect to the switches. You can select Auto
(recommended) or choose a serial port number from 1 to 8.
Auto-connect ioPower on Start: When checked, forces the
management software to connect to the switch(es) automatically. If
disabled you must choose Connect from the Setting menu to begin a
session. The setting is unchecked by default.
Touch-Panel Power ON/OFF Confirmation Prompt: Sets whether
the software will warn you before powering a port on or off from the
main menu. This setting in checked by default (recommended).
Choose OK to apply your changes to Cancel to discard them.
The Time Tab
This menu allows you to schedule power events using the drop boxes
on the menu.
Enable: When checked, will cause the event to occur. If unchecked, the
event will not occur even when values are entered.
Instruction Manual
8
The General tab
The Time tab