StarTech.com SAT3510U2V - Manual (Page 9)

Instruction Manual
6
7. Once the drive has been secured within the Enclosure, connect the DC 12V power
adapter to the power adapter port. Connect the remaining end of the power
adapter to an available power outlet.
8. Connect the USB A-B cable to the USB B port on the rear panel of the Enclosure,
then connect the remaining end of the cable to the host computer.
9. With the host computer powered on, power on the Drive Enclosure using the On/
Off switch. The operating system will detect the presence of the added drive,
following which you will be able to properly format/partition the installed drive
from within the operating system.
Driver Installation
No driver installation is required for the supported operating systems, as this enclosure
is natively supported, so the drivers are already installed.