SunBriteTV SB-WM32 Series - Manual (Page 6)

SB-WM32 Series Installation Instructions
6
PARTS
A
B
C
D E
F
G
QUANTITY By SB-WM
MODEL
ITEM DESCRIPTION 32NA 32 32D
A PIVOT PITCH WALL MOUNT 1 - -
B SINGLE ARM WALL MOUNT - 1 -
C DUAL ARM WALL MOUNT - - 1
D J-SERIES WALL PLATE 1 1 1
E CABLE MANAGEMENT COVER - 1 2
F HEX HEAD LAG SCREW, 3/8" X 3" 2 2 2
G PHILLIPS FLAT MACHINE SCREW, 8-32 X 3/8" - 2 4
INSTALLATION
WARNING: FAILURE TO PROVIDE ADEQUATE
STRUCTURAL STRENGTH FOR THIS MOUNT CAN
RESULT IN SERIOUS PERSONAL INJURY OR DAMAGE
TO EQUIPMENT! It is the installer’s responsibility to make
sure the structure to which this mount is attached can support
five times the combined weight of the mount and all
equipment attached to it. Reinforce the structure as required
before installing the mount.
1. Determine location for mount keeping in mind display size,
extension, height adjustment (if applicable), and pitch/roll
requirements. Use a stud finder to locate wood stud.
IMPORTANT ! : The SB-WM32 Series mounts are designed
to be mounted to a 2" x 4" wood studs wall.
2. Using wall plate (D) as a template, mark then drill two 1/4"
diameter x 3" deep pilot holes through top and bottom holes
of wall bracket into wall structure. Holes must located at the
center of wood studs. (See Figure 1)
3. Install two 3/8" x 3" hex head lag screws (F) through wall
plate (D) and drywall into wood stud. (See Figure 1)
4. Ensure wall plate (D) is vertical, then tighten screws (F).
(See Figure 1)
Figure 1
CAUTION: Overtightening screws may cause wall bracket
to compress into soft wall surface, resulting in difficult mount
installation or improper engaging of set screw in later step.
2
3 (F) x 2