Cyber Acoustics CA-461 - Manual (Page 6)

The CA-461 can also be powered by batteries making it a perfect portable solution. Simply install 4 AA
batteries in the battery compartment located at the back. Make sure to follow the battery indicators for
correct installation.
Using The System
Connections
Your iPod can be on or off when you place it into the dock connector. If your iPod is on and a music track
is playing you should hear sound immediately. If you don’t hear anything recheck that the track is playing
and the volume on the system is turned up slightly. The volume can be turned up or down using the
volume + / - buttons on the front of the speaker.
NOTE: When using the speaker with batteries be sure and turn off the main power
switch when you are not listening to the speaker. Stand by mode will put a slight drain
on the batteries if the main power switch is not turned off.
The power supply cord plugs into the DC jack located on the back of the system. Plug the adapter into
your AC wall socket or surge protector.
For use with batteries simply install 4 AA batteries in the battery compartment in the back. Follow the
battery indicator (+/-) to ensure they are in the correct position. If The speaker is going to be used by an
AC source for a long period of time it is recommended to remove the batteries.
Once again, make sure the correct insert for your iPod is in the universal well. Plug your iPod into the
connector pin that comes through the well/insert.
Turn the power switch on.
Battery Option
Rear panel
AC power adapter
Turn standby switch to the on position.
The LED indicator is red when in stand
by mode and is blue in on mode.
Rear panel
5