Sure Heat Sonoma SGIR27 Natural Gas Conversion Kit - Manual (Page 7)

4. Remove the two (2) screws holding the bezel and
valve in place. Remove bezel from the front of
the side burner. (See Fig. 11 on page 3)
5. Remove the two (2) screws holding the side
burner LP valve assembly in place. This will
free up the assembly. (See Fig. 31)
6. Holding the assembly securely, remove side burn-
er assembly from casting. Replace with new side
NG side burner assembly. (See Figs. 32 & 33)
7. Install the NG valve assembly to the under side
of the side burner with the two (2) screws
previously removed. (See Fig. 34).
Note: Make sure the NG valve is facing towards
the front of the side burner and the valve
stem is inserted into the hole.
8. Reattach the bezel to the front of the side burner
and the NG valve with the two (2) screws
previously removed. (See Fig. 35).
Note: Make sure the bezel is installed in the
correct position. The “H” will be facing the
igniter.
10. Reattach the control knob. Carefully run the
supplied hose from the inside of the cart through
the grommeted hole in the cart to the side burner
assembly. Connect the end of the new gas
supply hose to the NG valve assembly.
(See Fig. 36).
This completes the side burner conversion.
7
Fig 31
SGIR27 Natural Gas Conversion Instructions
Screw
Fig 34
Screw
Fig 35
Screws
Bezel
Fig 36
Underside of side
burner shelf
“H”
Fig 32
Casting
Side Burner Assy
Fig 33
Casting
Side Burner Assy