SUUNTO FAVOR S - Manual (Page 50)

50
5. Exit the Time Setting mode with the RETURN command, i.e. by connecting all
three contacts at the same time. First make contact between the PLAN/ON and TIME/
MODE contacts and after that with the COM contact.
NOTE: The clock is on (time is elapsing) when setting it and exiting the Time Setting
mode. It is not possible to reset the seconds.
Remember to regularly check that the clock is on time especially when traveling to
different time zones, as the entry time of all dives is stored in the logbook memory.
Fig. 4.15 TIME SETTING
Adjusting the ten minute reading (blinking),
PLAN/ON & COM.
Fig. 4.14 TIME SETTING
Scrolling through hours, minutes, month
and date, TIME/MODE & COM.