1 use of push buttons and water contact – SUUNTO SPYDER User Manual

Page 27

Advertising

4.1 USE OF PUSH BUTTONS AND

WATER CONTACT

The Dive Mode is controlled with the

, and the

and

push buttons and with

the water contact as follows (see also Section

1.3):
Activation of the Dive Mode: press the

but-

ton until the Dive Mode is indicated or immerse

the Spyder in water below 0.45 m [1.5 ft] for five

(5) seconds.
Dive Planning: in the Dive Mode, press the

button.
Return to Other Main Modes: press the

button.
The water contact is located on the right side of

the case (Fig 4.2 a). When submerged the con-

tact is connected to the case by the conductivity

of the water. Active water contact is indicated on

display by the ACW-text (Fig 4.2 b). When the

Spyder is submerged below 0.45 [1.5 ft] it goes

into Dive Mode and the Surface or Diving Mode

is automatically activated.

Fig. 4.2

a) The water contact and depth

sensor.

b) Active water contact is

indicated by the ACW-text.

200m/660ft

Advertising