Cobra Electronics Pro 9680 - Manual (Page 14)

Settings
Your Detector
Nothing comes close to a Cobra ® 23
Settings
Your Detector
22 English
DigiView Data Display Brightness
Your detector has a Bright display mode (for daytime driving) and three (3)
levels of Dim display modes (Dim for dusk driving, Dimmer for night driving
and Dark where no visual alerts will be displayed) to control the display’s
brightness levels. The factory setting is Bright. The factory Dim mode
default setting is Dimmer.
Select/Dim Button
Press and release
Select/Dim Button
Press and hold
Dark Indicator
.
To Change The Brightness To Dim
Press and release the
Select/Dim button once. Tone Visual Display
Two (2) beeps Dim, Dimmer or Dark
To Change The Brightness To Bright
Press and release the
Select/Dim button again. Tone Visual Display
One (1) beep Bright
Dim
Dark
Dimmer
Press
and hold
Select/Dim
button
Setting Dim Default
You can set the default level for Dim mode (Dim, Dimmer or Dark)
either in Program mode or directly using the Select/Dim button.
To Set The Display Dim Mode Default Directly Using The Set/Dim Button
Press and hold the
Select/Dim button Tone Visual Display
One (1) beep each time
the display cycles Cycles — see chart above
Release the Select/Dim
button to select the
current display as
default. None Dim, Dimmer or Dark
To Set The Display Dim Mode Default Using Program Mode
(See Page 7 For Instructions On Using Program Mode)
In Program mode,
go to Display Dim,
Dimmer or Dark. Tone Visual Display
Two (2) beeps Dim
One (1) beep Dimmer
One (1) beep Dark
NOTE
When you change to Dim mode, the unit will enter whichever
dim default mode is set at the time.
Dim Display
Dim
Bright Display
Bright
Dimmer Display
Dimmer
Dark Display
Dark