Chicago Electric SCREWING TOOL 95065 - Manual (Page 5)

SKU 95065 For technical questions, please call 1-800-444-3353 Page 5
Do not force the Cordless 6.
Screwdriver. This tool will do the work
better and safer at the capacity for
which it was designed.
unplug the Charger Adapter 7.
from the Cordless Screwdriver
and the electrical outlet before
use or before performing any
inspection, maintenance, or cleaning
procedures.
never leave the Cordless 8.
Screwdriver unattended while
running. Turn power off if you have to
leave the Cordless Screwdriver.
people with pacemakers should 9.
consult their physician(s) before
using this product. Electromagnetic
fields in close proximity to a heart
pacemaker could cause interference to
or failure of the pacemaker.
Connect the Charger Adapter to 10.
a Ground Fault Circuit Interrupter
(GFCI) protected electrical outlet.
GROunDInG
Improperly
connecting the
grounding wire can result in
electric shock.
Check with a qualified
electrician if you are in doubt as
to whether the outlet is properly
grounded. Do not modify the
power cord plug provided with
the tool. never remove the
grounding prong from the plug.
Do not use the tool if the power
cord or plug is damaged. If
damaged, have it repaired by
a service facility before use. If
the plug will not fit the outlet,
have a proper outlet installed
by a qualified electrician.
Grounded Tools:
Tools with Three prong plugs
Tools marked with “Grounding 1.
Required” have a three wire cord
and three prong grounding plug. The
plug must be connected to a properly
grounded outlet. If the tool should
electrically malfunction or break down,
grounding provides a low resistance
path to carry electricity away from the
user, reducing the risk of electric shock.
The grounding prong in the plug is 2.
connected through the green wire
inside the cord to the grounding system
in the tool. The green wire in the cord
must be the only wire connected to the
tool’s grounding system and must never
be attached to an electrically “live”
terminal.
3-prong plug and Outlet
3. The tool must be plugged into an
appropriate outlet, properly installed
and grounded in accordance with all
codes and ordinances. The plug and
outlet should look like those in the
preceding illustration. (See 3-prong
plug and Outlet.)
Double Insulated Tools:
Tools with Two prong plugs
Tools marked “Double Insulated” do 1.
not require grounding. They have a
special double insulation system which
satisfies OSHA requirements and
complies with the applicable standards
of Underwriters Laboratories, Inc., the
Canadian Standard Association, and
the National Electrical Code.
WARnInG