TC-Helicon Play Acoustic - Reference Manual - Manual (Page 13)

Basics
Play Acoustic – Reference manual (2014-07-16) 11
PEDAL connector
Use a TRS cable to connect a Switch-3 (optional)
to the PEDAL connector. If you use the Switch-3,
you have direct access to looping and other ef-
fect control. See the Switch-3 menu section for
details on assigning controls to each Switch-3
button.
USB connector
Connect to your computer with the included ca-
ble. Use the VoiceSupport software to manage
presets and update the product’s internal soft-
ware (firmware).
You can download VoiceSupport here:
tc-helicon.com/products/voicesupport/
Stereo audio input and output via USB is also
supported at 16 bit resolution with 44.1 or 48 kHz
sample rate.
Incoming USB audio signals are NOT passed to
the USB output, allowing you to sing/play along
with tracks from your DAW while recording back
“just the vocals and guitar”.
Power socket
Connect the included power supply. Your Play
Acoustic will power up immediately.
Always use
a TC-Helicon power supply (12 V, 400 mA).
Using any other power supply may damage the
unit and will void your warranty.