TeeJet ARC-6000 - Manual (Page 46)

98-05017
Rev.- 1
C-2
ARC 6000
CE & S
TANDARD
V
ERSION
C.0. INSTALLATION
C.1. CONTROL CONSOLE INSTALLATION
The ARC control console should be located inside the vehicle cab, when possible. It can be mounted on or below the
dash, or any other location where it is accessible to the operator without diverting or obstructing his view. The mounting
bracket may be attached to the console with the mounting face of the bracket up or down as required
C.1.1. CONSOLE MOUNTING
After selecting a suitable location for the console, drill two 9/32" diameter mounting holes, using the mounting bracket
as a template to mark the locations. Attach the mounting bracket to the mounting surface using two 1/4" bolts, lock
washer and nuts. Then mount the console to the mounting bracket using the well nuts and the knobs supplied.
WARNING: FOR POSITIVE GROUNDED VEHICLES; DO NOT select a mounting location that will allow the
console rear panel or the front panel toggle switches to come in contact with the vehicle frame. These parts are
negatively grounded and MUST NOT contact the frame of a positively grounded vehicle.
BRACKET
Can be attached at a
VARIABLE ANGLE
1/4" Bolt,
Flatwasher,
Lockwasher,
& Nut
CHECK
FOR DRILLING
CLEARANCE BEFORE DRILLING
9/32" HOLES!!
Use the Wellnuts and
Knobs provided to attach
the Control Console to the
Bracket.
ARC 6000
CONTROL CONSOLE
SIDE VIEW
NOTE: If the control console is to be installed on a vehicle without a cab or at any location which is
unprotected from weather or chemicals, the following precautions must be followed.
A. Install the console so that the front panel is tilted up no more than 45 degrees and no less than 10
degrees. This will allow any water that gets inside the console to drain through the holes in the
back of the case.
B. The console electronics are sealed to prevent damage from moisture, however if the console will
be exposed to weather, it should be covered when not in use. The best cover is one which would
protect the console from rain and yet allow for air movement from below. A plastic bag sealed
tightly around the console is NOT recommended, as this can cause excessive moisture and heat
build up inside the console.