Document Outline

• Chapter 1 - introduction
• Chapter 2 - Mounting Sprayer Components
  • Pressure Regulator in Bypass Mode
    • Pressure Regulator in Throttling Mode
    • Flow Meter
    • Boom Control Valves
    • Pressure Transducer
  • Installing the Speed Sensor Assembly
    • Components
    • Speed Step 1 - Location
      • Proximity Sensor (optional)
    • Speed Step 2 - Installing The Wheel Magnets
    • Speed Step 3 - Installing the Magnetic Sensor
    • Speed Step 4 - Confirming Speed Sensor Installation
      • Magnetic Wheel Sensor
      • Radar
  • Mounting The TeeJet 844 Console
    • Console Step 1 - Location
    • Console Step 2 - Mounting
    • Console Step 3 - Power Connection
    • Console Step 4 - Connecting Component Cables
    • Connect Step 1 - Wiring Layout
    • Connect Step 2 - Making The Connection
• Chapter 3 - Programming
  • Important Preliminary Information
    • Steps to Successful Programming
  • System Setup Mode
    • Program Units
      • Setting Your Program Mode (U.S., Turf, NH3, Imperial, S.I.)
    • Reset Defaults
      • Reset To Default Settings
    • Sensor Type
      • Flow Meter or Pressure Based
    • Flow Meter Calibration
      • Flow Meter Pulses
    • Pressure Transducer
      • Maximum rating (P Hi)
      • Low Pressure Calibration (P rEF)
    • Nozzle Spacing
    • Tips Per Boom Section
      • Number of Spray Tips Per Boom Section
    • User Program Tip
      • User Programmable Tip
    • Pressure Regulation
      • Pressure Regulation Mode
    • Regulation Adjustment Speed
    • Control Valve Type
      • Boom Control Valve Type: 2-Way/3-Way
    • Calibrate Speed
      • Speed Sensor Calibration
      • Proximity/Magnetic Pulses
        • Automatic Calibration
        • Manual Calculation:
    • Radar Speed Pulses
      • Automatic Calibration:
        • Manual Calculation:
    • Distance Counter
    • Simulated Ground Speed
    • Program Specific Gravity
    • Liquid Specific Gravity (Density)
    • Communications
    • Minimum Pressure
      • Minimum Regulating Pressure Setting
  • Application Setup Mode
    • Target Application Rate
    • Nozzle Selection
      • Required Speed to Achieve the Application Rate
    • Calculation Troubleshooting
      • Adjust Speed:
      • Adjust Pressure:
      • Liquid Density:
• Chapter 4 - Operating Instructions
  • Sprayer Checkout
    • The Spraying Operation
• Chapter 5 - Features
  • Boost Mode
    • Area/Volume Feature
    • Flow Rate Feature
    • Application Alarm
    • No Flow Alarm
    • Printing
• chapter 6 - Troubleshooting Guide
• Chapter 7 - Flow meter Calibration
  • Method 1 – Known Volume
    • Step 1 – Known Value
      • Step 2 – Programming Calibration Number
      • Step 3 – Resetting Volume Counter
      • Step 4 – Spraying Known Volume
      • Step 5 – Entering in New Flow meter Calibration Number
      • Step 6 – Double-checking the New Value
    • Method 2 – Known Tip Size Method
      • Step 1 – Check Tip Size
      • Step 2 – Count Tips
      • Step 3 – Calculated Flow
      • Step 4 – Measure
      • Step 5 – Adjustments