TeeJet LH 865 - Manual (Page 11)

LH 865 C APACITY INDICATOR – O PERATORS MANUAL & F ITTING INSTRUCTION
LH A GRO 11
SUPPLY VOLTAGE
The supply voltage is 12 Volt.
Connect the supply cable to 12 V in a way that the supply is switched off. When
the ignition is switched off.
OBS:
Blue cable to +
Brown cable to –
Lead the cable to the connection box and connect as shown on the circuit board.
MOUNTING OF WHEEL SENSOR
Mount the sensor on one of the steering wheels.
The magnet is to mount direct on hub or rim. The supplied 20 mm collar must be
used as support.
Mount as follows:
1. Mount the bracket for the censor. (Screw or weld).
2. Mount the sensor in the bracket.
3. Mount the sensor as illustrated below (cut 4 mm thread).
5-8 mm
M4
Magnet can be painted
Washer
4. Turn the wheel and check the distance between sensor and magnet (5-8mm).
5. Lead the cable to connecting box 2 and connect it as described.
6. Fix the cable and control that it will not be squeezed or worn.