TeeJet Matrix Pro 840GS - Manual (Page 70)

64
www.teejet.com
HOME
OVER
VIE
W
SE
TUP
IMPLEMENT
FULL SCREEN
GPS
INTR
ODUC
TION
GUID
ANCE
DR
OPLE
T MONIT
OR
Figure 8-18: Overlap
100% 50% 0%
OEM spreader implement type
1. Select
Spreader
implement type on implement screen.
2. Press NEXT PAGE arrow .
3. Select from:
►Setup type – used to select
OEM
spreader type
►Antenna to disks – used to enter the distance from the
GPS antenna to the delivery disks or dispersal mechanism.
Range is 0.0 to 50.0 metres.
►Start distance – used to set the start distance when exiting
an applied area. Consult spreader manufacturer for value.
►Stop distance – used to set the stop distance when entering
an applied area. Consult spreader manufacturer for value.
►Section start offsets – used to set the offset distance from
the leading edge of Section 1 to the leading edge of each
section. Section 1 is always 0.0 metres. All other sections
can be a different distances. Sections are numbered from
left to right while facing in the machine's forward direction.
Consult spreader manufacturer for values.
►Section stop offsets – used to set the offset distance from
the leading edge of Section 1 to the trailing edge of each
section. Each section can be a different distances. Sections
are numbered from left to right while facing in the machine's
forward direction. Consult spreader manufacturer for value.
4. Press RETURN arrow to return to the implement screen
or CONFIGURATION side tab to return to the main
configuration screen.
Figure 8-19: Implement setup options in OEM spreader mode
Staggered implement type
1. Select Staggered implement type on implement screen.
2. Press NEXT PAGE arrow .
3. Select from:
►Section 1 offset direction – used to establish if Section 1
(the zero-point of the section offsets) is located in front of or
behind the GPS antenna as the vehicle moves in a forward
direction
►Antenna to Section 1 distance  – used to enter the
distance from the GPS antenna to section 1 (the zero-point
of the section offsets). Range is 0.0 to 50.0 metres.
►Overlap – used to select the amount of overlap allowed
when the sections are turned on and off while using
automatic boom section control