TeeJet RX375P Receiver - Manual

www.teejet.com
InstallatIon
Rx375p ReceIveR
InstallatIon and specIfIcatIons
Mounting considerations
1. When mounting the RX375P Receiver, a space of
at least 6 inches (15 cm) between the receiver and
any bend in the cable is required. Any length shorter
than 6 inches puts undue stress on the cable and the
enclosure for the RX375P.
2. The Receiver should not be mounted where water can
pool around it. The receiver housing is designed to
withstand rain and splashing, but not submersion in
liquids for sustained periods of time.
3. Mount the receiver above all other metal objects to
avoid multipath. Satellite signals received by the GPS
receiver by a reflection from an object can decrease
positioning accuracy. For example, roof racks, large
headlight enclosures, etc., can cause multipath that
may result in a jump in GPS position.
5.7 inches / 14.5 cm
4.1 inches / 10.4 cm
LED Status Indicator
Red - power is ON
Amber - GPS lock
Green - DGPS solution
Deutsch connector
Port A:
4800 GGA 1Hz
VTG 1Hz
Port B: 19200 GGA 5Hz
VTG 1Hz
Rx375p Receiver Installation
1. Make sure the surface of the vehicle is clean, dry, and free of dust particles.
2. To magnetically mount the RX375P, attach the black magnetic base unit to
the underside of the receiver and mount it to a metal surface.
3. To mount the receiver to a fiberglass surface, remove the adhesive pad
and attach it to the vehicle. Adhere the metal disk to the other side of the
adhesive pad, holding firmly in place for 10 seconds to ensure a secure
connection. Magnetically mount the RX375P to the disk.
Mount antenna at a minimum of 6 inches (15 cm) before
applying a bend to the cable