TeeJet LH 1000 - Manual (Page 6)

G ENEREL OPERATION LH 1000 O PERATORS & F ITTING MANUAL
6 LH A GRO
THE LH 1000
The LH 1000 is a very simple monitor to operate, which is able to monitor the
following:
NB! The six functions contained in LH 1000, are arranged in two sets and cannot
be used simultaneously.
Function set 1 Function set 2
! TIME ! TIME
! AREA ! RPM
! FORWARD SPEED ! DISTANCE
! UNITS
All the functions within the selected set of functions are calculated simultaneously.
This means, that you can monitor, e.g. your speed, and at the same time the
monitor counts area and time.
All entered values and gathered data are stored in a memory, if power,
deliberately or not, is cut off.
LH 1000 can be used on the following:
! TRACTORS
! COMBINE HARVESTERS
! MOBILE SPRAYERS
! IN FACT ANY AGRICULTURAL MACHINE
On the following pages you will find a description of how to encode, use, test and
fit your LH 1000.
SECTION FUNCTION
With this function the working width is divided into four equal sections. This section
function reduces the area measured by the number of sections that have been
switched off. This function works as follows:
!
Pressing the numerical key "1" will reduce the working width to 1/4 of the
encoded working width.
! Pressing the numerical key "2" will reduce the working width to 2/4 of the
encoded working width.
! Pressing the numerical key "3" will reduce the working width to 3/4 of the
encoded working width.
Full working width can be achieved manually by pressing the numerical key "4" or
automatically when the implement sensor is activated.