TeeJet LH 1200S - Manual (Page 4)

4 LH A GRO
CONNECTIONS IN THE PULL AWAY PLUG
(Seen from the maunting side)
Note: The special 7-poled plug allows connection of many different types of
sensors on machines and implements (eg. count, flow and RPM).
See the different possibilitiess on the last page.
Signals in the 7-poled plug:
Pin 1 N/A
Pin 2 Flow or RPM
Pin 3 N/A
Pin 4 Speed transmitter
Pin 5 0 V (negative)
Pin 6 12 V (positive)
Pin 7 Override sensor
HOW TO MOUNT THE SPEED TRANSMITTER
Note:
Mount 2 magnets on the navel (180°
apart), use the wheel bolts for precision.
The yellow marks (south) must face the
sensor.
You can glue the magnets. The gap
between the magnets and sensor must
not exceed 5 mm.
Take care when tightening the sensor
(tighten lightly).